How do you remove a crankshaft pulley without a puller?

There is a way to do it. You put a wrench on the pulley bolt and block the other end against the floor or the frame. Then you use the starter motor to turn the engine (DO NOT START IT, JUST TURN IT) for at most one or two revolutions of the crank. Just enough to break the bolt loose.

Thereof, how do you remove crankshaft pulley?

Disassemble the crankshaft pulley You just have to place one end on the bolt-removing tool and slacken the bolt using an impact wrench. With the bolts included in your tool, you may now tighten the bolt remover tool. Keep doing this step until the crankshaft pulley is finally released.

Additionally, how do you remove a crankshaft? How to Remove a Crankshaft From Under the Car

  1. Remove the engine’s belts.
  2. Remove the pulley which attaches to the harmonic balancer.
  3. Remove the harmonic balancer.
  4. Drain the radiator by removing the radiator’s drain plug.
  5. Remove the water pump.
  6. Remove the timing chain cover.
  7. Remove the timing chain.
  8. Remove the oil pan.

can you remove a harmonic balancer without a puller?

Step# 5 Using Durable Straps to Remove the Harmonic Balancer If you don’t have a puller or you don’t want to buy it, you can use a durable strap in pulling it. Simply insert the strap in the space and around to position the strap firmly around the center of the balancer.

How do I know if my crankshaft pulley is bad?

Bad Crankshaft Pulley Symptoms

  1. 1) Engine Vibrations. The first symptom that will likely come up are engine vibrations.
  2. 2) Alternator Failure. The crankshaft pulley is responsible for powering the alternator.
  3. 3) Power Steering Pump Failure.
  4. 4) Transmission Damage.
  5. 5) Irregular Idle Engine Speed.

20 Related Question Answers

Similar Asks