How do I fix e1 error on Fisher and Paykel dishwasher?

VIDEO

Consequently, how do I reset my Fisher Paykel Dishdrawer?

Reset Procedures for the Fisher & Paykel Dishwasher

  1. Press and hold the button decorated with the key and lock image for five seconds.
  2. Press the power button to turn off power to the Fisher & Paykel dishwasher.
  3. Wait a few minutes and then press the power button to restore power.
  4. Turn off and unplug the dishwasher if the issue remains.

Also, why is my DishDrawer beeping? The drain filter must be level with the filter plate. Close the drawer and press the button. The DishDrawer® will beep six times to indicate the end of the wash programme. It is normal for some water to remain in the drain filter area after the wash programme is complete.

Hereof, what does f1 mean on a Fisher and Paykel dishwasher?

F1 on Fisher & Paykel Dishwashers. F1 means that there is water in the base pan below the bottom drawer. This usually happens because something was stacked too high in one of the drawers when it was running and this caused the lid to not seal up when the drawer was shut.

How do I fix e6 error on Fisher and Paykel dishwasher?

Check hose and straighten if needed. Be sure the drain hose is connected per the installation instructions. Fisher and Paykel Dishwasher Dishdrawer Error Code E6 = The first 4 program indicator lights are flashing. Error Code Cause: Flood switch activated.

Related Question Answers

New Post